How to Fit the Heater.
|
|
| It is important that you follow
the simple drawings that you will be supplied with when you
are fitting your Elecro Heater into your system.
The reason for this is to ensure that the body of the
actual heater is always full of water - thus preventing half
the heating element to be out of water which would, of course,
cause the element to overheat and burn out ..
You can either choose to use 90 degree bends or 45 degree
bends which are a little gentler with the interrupted flow.. |
 |
| .. this then
means that for water to even trickle out of the upper section
of the pipework return to your pond ... that there will always
be water in the heater and covering all of the element ....and
if possible the Heater should be placed before the Ultra
Violet Clarifier as this then prevents and single cell algae
that has been 'zapped' by the UV rays from collecting on the
'Flow Switch' contained within the body of your new heater
unit .. which is of course one of the built in safety trips in
your heater ..
If you are still unsure - or need any further advice ..
then please do not hesitate to either telephone or email me
and I will do my best to help you out ...
The drawing below is for a 'Gravity Fed' system where the
'clean water' is being returned to the pond after passing
through the filtration system..
If you have a 'Pump Fed' system, where the water is being
pumped to the filter from the bottom of the pond then you
should contact The East Riding Koi Co for further advice on
fitting a heater, before you buy one .. please either
telephone on 01377 24 00 32 or email on <info@koicarp.net>
|
| We can supply 1.5" threaded hose
tails for attaching flexible hose which - to the
Heater.
These ABS hose tails will accept both 1.25" and
1.5" flexible pipe...
Product Code HOS-103 Click
Here
| SKU |
Description |
Price |
Order |
| HOS-103 |
ABS Hose tail - Threaded |
£5.37+ Vat |
 |
|
 |
| For those who are using Hard Pipe
then we have the 1.5" Male Threaded connectors you
will require ..
Product Code: ABS-138 Price £2.30 pair + Vat in the
UK and EEC
| SKU |
Description |
Price
|
Order |
| ABS-143 |
1.5-inch White ABS x Male Threaded Socket Nipple |
£1.35
+ Vat |
|
|
 |
| To enable you to remove the Heater,
for whatever reason, we have a 1.5" Male threaded
Union - and we do recommend that you do use these or fit
another Union connector ...
We can supply a pair of these for just £12.50 + Vat
in the UK and EEC
Product Code: TMC 101
| SKU |
Description |
Price
|
Order |
| WA-144 |
1.5-inch
White ABS x Socket Male Union Nipple thread |
£6.48
+ Vat |
|
|
 |
|
